Forum Discussion

MichaelMazo's avatar
MichaelMazo
Community Member
3 years ago

Dial Activity Reset

I have added a dial activity to my course. As the dial moves to shows different layers of information. Each layer on the page is set to "Reset to initial state". When the activity is complete, and t...
storyline 360
elizabeth's avatar
elizabeth
Partner
3 years ago

Hi Michael! Great question. I'd do two things: 1.) Double check your slide properties on the base layer where your dial lives, and make sure that's set up to "Reset to initial state" and 2.) Add a trigger on the base layer to set the dial value back to its initial value when the timeline starts on the slide. That way, if a user revisits the dial slide, it should go back to the beginning. I recorded a short peek for you with an example: https://360.articulate.com/review/content/692feef0-cb4e-4e0b-a03f-081b7a533f1c/review

  • Ivo's avatar
    Ivo
    Community Member
    2 years ago

    Hi Elizabeth, I am having the same problem than Michael. I have followed your very clear recording, but still getting the same problem.

    In my case, in stead of using a pre-built dial, I have converted a picture into a dial. Could this cause the problem, or it should behave exactly as a normal dial?

    Thanks