Not sure if this is a laptop memory issue, a browser issue or a SL issue. I have 7 branches that are reached on one page by 7 clickable arrows on a slide: each with Normal, hover, visited and Selected states.
When I publish and click arrow 1, and return all is fine-6 arrows are Not visited, 1 is not visited. When I click arrow 2 it branches as it should. Bit when I return arrow 1 is still in the Hover state until I wiggle my mouse over it-then it changes to Visited as it should.
Hover state works fine. But the Visited state is wonky without a little persuasion. Anyone have any idea what's happening?
2 Replies
Figure it out. Somehow or another a Glow was added to the Selected state. After removing the Glow effect to the Selected state all is well.
Hi, James.
Thank you for taking the time to share the solution, as others might benefit from this discussion!