Forum Discussion
Freeform Question Text Entry (Storyline 360)
Hi, Keith.
Thank you for reaching out!
You can also use the same logic with a layer:
- Create a new layer and insert your text entry. Make sure it's at the bottom of the timeline.
- Create a trigger to Show the layer when the timeline starts on your base layer.
Let me know if this works!
Thank you, this did work.
Keith Nikitin, Sr Instructional Designer ⁞
nThrive
P: 678.248.8390
200 North Point Center, Suite 400, Alpharetta, GA 30022
We make healthcare revenue cycle management simple, efficient, accurate
www.nthrive.com
*****Attention*****
This electronic transmission may contain confidential, sensitive, proprietary and/or privileged information belonging to nThrive, Inc. and its affiliates. In addition, it may also contain patient health information, which may be subject to protection under federal and state privacy laws, including but not limited to the Health Insurance Portability and Accountability Act of 1996, as amended (HIPAA). Authorized recipients of this information are prohibited from disclosing the information to any unauthorized party and are required to properly dispose of the information upon fulfillment of its need and/or use, unless otherwise required by law. Access to this transmission (including any attachments) by anyone other than the intended recipient is not authorized. If you are not the intended recipient, you are notified that any use, dissemination, distribution, printing or copying of this transmission is strictly prohibited and may subject you to criminal or civil penalties. If you have received this transmission in error, please notify the sender and immediately delete this message from your computer.
