Shapes moving out of alignment in preview mode

Hi Larry,

Thanks for reaching out here - this discussion is a bit older, so I had to dig a little bit further back, but I found the issue as reported in SL1, and I was able to replicate it as you mentioned within Storyline 2 and 360. Part of the issue seems to lie in the way in which I have to crop the original image to make the fourth of the pie and then get them to line up again, and that continued duplicate of the first image causes it to be more noticeable by the time I'm trying to line up the third duplicate.

Our team does continue to monitor the way issues such as this impact our customers and figuring out how a change might fit in with other priorities--so likely based on the time passed on this one, it seems it didn't rise to the top. I did report this anew to our QA team for Storyline 360 and determine if we can get a bit more information about the cause and ways in which it could be fixed. I'll be back in touch here once I have any additional insight to share, so I appreciate your patience on that!