Forum Discussion

DorothyBaker's avatar
DorothyBaker
Community Member
12 years ago

Shapes moving out of alignment in preview mode

I have shapes nicely aligned in the normal view (stacked rectangles to make a gauge) but when I preview it, they are all akilter.   This also happens to some other shapes I have stacked.  When it is...
storyline 360
AshleyT-Pollard's avatar
AshleyT-Pollard
Staff
9 years ago

Hi Sandra,

There is still an open issue with our QA team in regards to this behavior, but I did notice taking a look at your images that it appeared you were viewing the content off of your H drive? I wanted to double check if you're able to see the same thing when you've edited and published the content locally, and then viewed in the intended publish environment - as working on a network or shared drive on the .story files is known to cause some odd behaviors and ultimately file corruption while viewing the published content locally could also cause things to not display as expected. 

If you'd like us to take a look at your file to confirm, we’d be happy too. You’ll want to upload the .story file here (which is the file prior to publishing) using the “ADD ATTACHMENT” button at the bottom of the forums reply window. If you’d prefer to not share in the public forums you’re always welcome to share with our Support Engineers here. They’re available 24/7 to assist! 

  • SandraWade's avatar
    SandraWade
    Community Member
    9 years ago

    I was working on my local drive and then published to a shared drive to view. My work around was to replace the shapes with images as those were not impacted and I was concerned the behavior would occur again when I published to the LMS.