Forum Discussion
Storyline: Slider Tool Not Resetting
I'm having trouble resetting my slider tool to "normal" after hiding the "Incorrect" layer. I've adjusted the slider to reset when the base layer starts, and I've added another trigger that changes my "Do Oval" to normal when the base layer starts, but none of those seem to be working.
Appreciate your guidance!
Moving a slide adjusts its variable. But you can also move a slider by adjusting its variable. So, in this case, the Try Again button should adjust the variable to the middle position.
This is done in the attached file. You'll also notice that I simplified the slider. There's no point in having 10 steps when you only need Do, Neutral, and Don't positions. In my edited version, step 1 = Do (left side), step 2 = Neutral (middle position), and step 3 = Don't (right side).
- JudyNolletSuper Hero
Moving a slide adjusts its variable. But you can also move a slider by adjusting its variable. So, in this case, the Try Again button should adjust the variable to the middle position.
This is done in the attached file. You'll also notice that I simplified the slider. There's no point in having 10 steps when you only need Do, Neutral, and Don't positions. In my edited version, step 1 = Do (left side), step 2 = Neutral (middle position), and step 3 = Don't (right side).
- AlisiaLeyvaCommunity Member
Thank you so much! I tend to overcomplicate in Storyline sometimes. I appreciate your feedback and advice!
- JudyNolletSuper Hero
You're welcome! Pay it forward when you can. 🙂