Forum Discussion
Set the Initial View for 360 Image project in "Guided Tour" mode
Hi there, I see that one cannot set the initial view if the mode is "Guided tour" and there is a marker that is on the opposite side of the image. How to tackle this? The initial view works fine if the mode is "Free Navigation", but if the mode is "Guided tour", the initial view defaults to the view where the first marker is. I know there is a logic behind this to happen but will there be a workaround to set the initial view elsewhere and still have Guided tour?
Thanks
Bobby
3 Replies
Hi Bobby,
Thanks for reaching out!
You can set the initial view for your 360° image by following the instructions in this article:
You'll need to edit your image to be able to set the initial view, shown here:
Let me know if this works for you!
I'm going to confirm what Bobby originally wrote: you can't Edit a 360 image's interactions if it's in guided tour mode, only when it's free navigation.
This is, in my non-humble opinion, a mistake.... and even if you do set the initial view, that setting is ignored, at least in preview, and you still see the default initial view (the center of the equirectangular image).
OK, tried it in Review 360, and confirm that setting the initial view has zero effect.
