Forum Discussion
Show additional layer after all other layers visited
Hello,
I have a series of layers that I want each user to visit before they can continue to the next slide. I have successfully created triggers to make the final layer appear after they have visited all other layers. However, if they click on one of the layers after they have all been visited, the final layer disappears and I can't get it to reappear without going through all the mandatory layers again. How do I get the final layer to stay visible after they have gone through the required layers? I have attached the file.
Hi Elizabeth!
I do this kind of thing all the time. Here is how I would have done it. Not necessarily the "right" way or the best way, but I hope it helps. The only way I could get it to work this way was removing the users ability to click straight through rather than go back to the menu. There is probably a way to do it though, I just couldn't get that to work in the time I had to work on this. Good Luck!
Thank you! I see that it works the way it is intended when you remove the option to click straight through. I'll see if that works for our end.
Hi Julie,
I see in your file that button 9 is hidden when you start clicking the buttons. How are you able to keep it from appearing before the user has visited all the slides?
Normally I would have put it on it's own layer as you did, but because you wanted it to be usable even if users revisited the other layers I put it on the base layer and paused the timeline at 4 seconds until all the other layers are visited. Then the timeline resumes, and button 9 is set to appear right after that. Make sense?
