Forum Discussion
View, Try, Test Mode
I am working on a project that will require the view, try and test modes in a series of screen recordings. I have no trouble doing the recording and using it to insert the view scene and the try sc...
Hi Susan,
Found this tip from another thread: https://community.articulate.com/discussions/articulate-storyline/help-convert-a-simulation-from-view-mode-to-try-mode
Summarised below. You can use the same method to change from View to Try to Test.
- Go to Home>Record Screen drop-down (see attached screenshot View to Try Mode 1.png)
- You will see a list of your recordings. Select the one that says In Use (in the example attached screenshot View to Try Mode 1.png).
- The Insert Slides window opens again and you can re-chose your options to Try Mode Steps, and Insert Slides in New Scene (if you want to create a new Scene for the Try-mode version). See attached screenshot View to Try Mode 2.png.
Thanks Jina. I've been following that procedure, but after I've published the test slides (and saved them) they disappear! I'm just going to have to go for the manual approach at this stage I think.
