Forum Discussion
apply different transitions to different layers on the same slide
Hello
it was said that this is possible.
I can only confirm that "If you're on a layer, it'll apply the same transition to all other layers for the current slide" but I would like to assign different effects to different layers. I can't figure out how this works.
In addition, I would like to better understand which ones do not work and which ones do, so far I have problems with the latter, no matter which browser I use.
Thanks for Feedback
Uli
4 Replies
you should be able to add different transitions for each layer, if you cannot may need to raise a support case
Hi Uli,
Thanks for sharing what you are experiencing and I'm glad that Phil was able to chime in and help you here.
To answer your question regarding what does not work:
- Push and Uncover transitions aren't available for layers.
- Storyline 360 and Storyline 3: Some Animations and Transitions Don't Work in Internet Explorer or Microsoft Edge
I want to take a look at your project file to investigate what's happening with your permission. You can share it publicly here or send it to me privately by uploading it here. I'll delete it when I'm done troubleshooting.
Hello Leslie
Thanks for the support and your offer.
I think I found a different solution/approach, will get back to you if help is still required.
Have a good weekend.
Uli
Hi, Ulrich.
I'm glad to hear you're close to a solution!
I just wanted to add a quick note: it looks like your signature with contact information came through when you replied via email. You can remove it by clicking 'Edit' below your response. Here's a quick Peek 360 video if you need help.
