Forum Discussion
Button trigger not activating layer
Hi everyone,
I am struggling to find a solution for this problem. I have four buttons that reveal a layer with information. My hope is that once all four buttons have been accessed, a "continue" button would be revealed as a layer, allowing the user to click and move to the next slide.
This is the trigger I have used. When the state of all four buttons shows as visited (I changed their visited state to make sure) the layer is not revealing.
Any advice on how to fix this? I can't seem to get it working.
This same problem was in a post yesterday ( Variables & triggers | Articulate - Community ).
Buttons automatically change to Visited when they are clicked. That trigger to show the final layer does run. However, it runs before the trigger to show the information layer associated with the last-clicked button. That all happens so fast that you don't even see the Done Button Layer.
Even if you could make it run after (which you can't), then the user wouldn't have time to see the last information l
You need to redo the slide so that the Continue button shows after the final layer has been viewed. How you do that depends on your overall design.
