Forum Discussion
Dial not resetting when I return to a layer
Hey Carmen, a dial will always reflect the value of its underlying variable, even if you revisit the slide and it's set to 'Initial State'.
I'd add a trigger at the start or 0 secs on the timeline to "Set variable Dial1 to [Start Position]".
This should reset your dial on return visits.
Hey Carmen, a dial will always reflect the value of its underlying variable, even if you revisit the slide and it's set to 'Initial State'.
I'd add a trigger at the start or 0 secs on the timeline to "Set variable Dial1 to [Start Position]".
This should reset your dial on return visits.
Hi Jonathan,
I'm delighted to report that this has worked! Thank you so much for your help. I was pulling my hair out over this! 😂
Glad I could help. It's one of the reasons I like working with dials so much. Once you grasp their logic, you can use them in lots of different ways by exploiting the relationship with its underlying variable.
For instance, you could put the dial in a Disabled state, meaning it cannot be moved 'by hand', but then change its position by changing the variable. In this way, both dials and sliders can make good 'progress meters'
