Forum Discussion
YouTube Video
I get the embed code from YouTube, add a section for Multimedia > Code snippet > I add the code but then nothing happens. The code is just there. Nothing changes in the preview view either. What am I doing wrong? Thanks so much in advance
Yesa, that's what the code snippet is meant for. To show the code without executing it, or without it creating errors by browser security.
You should use Multimedia > Embed
Good luck.
Richard
Yesa, that's what the code snippet is meant for. To show the code without executing it, or without it creating errors by browser security.
You should use Multimedia > Embed
Good luck.
Richard
Thanks for your answer but then the code doesn't show what is supposed to show when I preview it.
Hi Charlotte,
That's strange but ... are you actually copying the embedcode?
I attached a few screenshots to show where the embed code lives. Because sometimes people mistake the URL for the embedcode.
Excellent choice to use one of Nejc's videos for your instructions. 👍
Yes that part is all good, the problem is when I add it into Rise, it just shows the code and not the video when I preview it. Any other troubleshooting steps you recommend? Thanks so much
Strange. Can yo show what you do en what the result is?
