Forum Discussion
Show layer displays solid white using variable.
Here is the story file.
Thanks for uploading your file. If you change the highlighted trigger in the image to react when the value is True, the instruction layer shows as desired.
The way you have this set up will only show the layer if the variable is False, but the variable is set to True when the timeline starts.That is very helpful. I appreciate your time.
I just tried it and it partially works better now. Now it shows the instruction layer as I wanted but then goes to a white screen again after 1 second. I assumed this is because that is the timeline length so I adjusted the layer to 5 seconds to verify - and it indeed shows a white screen after the 5 seconds is up.
An issue with extending the timeline on the layer is that now is when the learner scrolls back through the video, the instructions layer stays until the 5 seconds is up, covering the video layer. Do you have any suggestions for that? I was hoping there was a logic setup that I could do that triggered something like, if the timeline is not at the end then hide layer. I tried reusing the trigger you highlighted and using it a bit differently but no luck.
Hi there, that's happening because the 'Hide slide layer when timeline finishes' box is checked in the layer properties.
