Forum Discussion
Custom failure layer shows in preview, but not when published
Hello,
In Storyline 360, I created a custom "failure" layer for my quiz results slide which works in the preview but reverts to a built in layer when I publish in review 360. Any suggestions f...
When I publish your project to Review 360 a custom "failure" layer will never show because you have unlimited number of attempts to take the quiz. The Try again layer would keep looping until the correct answer is provided which in turn leads straight to the Success layer on the Result slide. When I limit the number of attempts to 1 or more, a custom "failure" layer will eventually show as it appears on the Result slide in your project (attached photo).
