Forum Discussion
Solved
Drag and Drop - Try Again Layer looping
I have a drag and drop free form slide where a learner chooses three items, out of four choices, to put them in the correct order.
Learner will have two attempts to answer, if they keep answer...
Have the motion paths on the Incorrect layer run based on the Timeline (not on clicking Continue).
First, run the 0-pt motion paths, perhaps when the timeline starts or shortly thereafter.
Then I suggest you allow a little time before you run the motion paths that move the appropriate items into the correct spots. Those would be "when timeline reaches ___" triggers. I suggest you experiment to see how fast those paths should move and when they should start.
OMG thank you so much! This community is so fantastic!!!!!
We've fixed the issue of not triggering the incorrect or correct layers. Yay
So a few questions, hope you don't mind.
- Add the same triggers re: motion paths to the Incorrect layer to reset them back to the original when they click Continue from the Incorrect feedback?
- To show the learner the correct order once they have gotten the question incorrect 2 times would you add a 'correct layer' that shows the correct order?