Forum Discussion
Editing Branching in Storyline is so very difficult. What am I doing wrong?
Hi, this sounds pretty abstract. Is the situation that you are adding new content and there's no way to fit it on existing slides? If so, I hear you -- that's no fun. In that case, to add one slide, you'd have to change two existing slides to connect to the new slide, and then of course, configure the new slide. This is drudgery, but it doesn't have to be complex.
Another thing you can do is to print out a map of your course, so you know exactly where everything is going, and then you can draw in where the new stuff goes. I find having this helps keep me oriented.
Lastly, it sounds like your project is due for some "re-factoring". It's always good to stop and ask if it needs to be as complex as it is. In the worst case, there's no change, but best case, you can make it easier going forward.
Hope this helps.
Thank you for your response. Unfortunately, at least in this case, I have to add new slides. So the drudgery will begin.
What steps should I take to print out a map of the course?
Thanks again. :)
Ah, ok. I understand. I've used Function-Print Screen (Windows), then used a graphics editor to increase the size if it was too small.