This user guide covers the line color options on the Format Shape/Format Picture window. (See this user guide for ways to access the formatting window.)

Line color formatting options in Articulate Storyline 360

To change the line color of an object, use one of these options on the Line Color tab:

No Line

This removes the outline from the object.

Solid Line

This applies a single color to the outline.

Use the Color selector to choose a theme color or standard color. To pick a color from anything visible on your screen, click Eyedropper, then select a color that’s visible on your screen. For even more flexibility, choose More Colors and do any of the following:

  • Click the color you want—either a square color swatch or a color in the spectrum area.
  • Create a custom color by entering color values in the Hue/Sat/Lum fields, the Red/Green/Blue fields, or the Html field.
  • Use the eyedropper tool to match the color of anything visible on your screen. Just click the eyedropper, then click any color on your screen.

If the color you've chosen is something you want to save for easy selection later, click Add to Custom Colors. The color will get added to the bank of custom colors in the lower left corner. When you're finished, click OK to close the window.

Back on the Format Shape window, drag the Transparency slider or enter a percentage to make the object semi-transparent.

Gradient Line

This applies a gradient of two or more colors that blend into one another.

Use the Preset colors selector to choose from several ready-made gradients, or use the other fields on the window to create a custom gradient.

Type

Choose Linear, Radial, Rectangular, or Path. (Path means that the path of the gradient follows the perimeter of the object.)

Direction

Use the drop-down to choose one of the preset directions. (This field is grayed out for path gradients.)

Angle

If you're using a linear gradient, this field lets you specify the angle of the gradient.

Gradient Stops

Use a gradient stop for each color in your gradient. You can add and remove gradient stops by clicking Add or Remove. Set these properties for each gradient stop:

  • Stop position: Drag the slider or enter a percentage to indicate where you want the new color to start.
  • Color: Choose from the colors shown or select More Colors to choose a custom color.
  • Transparency: Drag the slider or enter a percentage.