Forum Discussion
add trigger witj motion path
Hi guys
I added a "motion math" trigger on some images.
Simple idea :
- when cursor overlays an image, the image has to move upwards.
- then, when cursor moves out of the image, image shoul go back to its initial position.
However, I encountered TWO issues :
1) When my cursor overlays the image : image seems to go down before going up (it's ONLY suppose to go up)
2) when cursor goes out of the image : again, the image move a little down before going back to its initial position
I can share my project if you want to have a look :)
Thank you very much !!
Hello Hanaë,
Thank you for reaching out and sharing what you are experiencing. It would be best to take a look at your .story file.
Please share your project file with our support engineers here. It will be deleted when troubleshooting is complete.
thank you leslie
I do it right nowIt sounds like the beginning points of the two motion paths are not accurately set. You can adjust them using the X and Y values in the ribbon. Go to Animation, and select the relevant motion path, and its X, Y, and length values show on the ribbon. If it has a width value, that means it is not moving straight up and down. Also be sure the start position is set to relative.
I adjusted them so that the starting point is located in the barycenter of my pictures.
When I click on "relative" position, I don't get the effect I want : the picture goes up when I slide my cursor on it and it doesn't go down afterwards (it continues to go upward everytime I fly over it....
Are you looking for something like the attached sample?
that's exactly what I'm looking for ! (faster but same motion path)
I can see you made two condtions ....
