Forum Discussion
Quiz results triggers
When using the standard results slide, how would I set up triggers to show a failure/success layer? Do I even need to mess with the triggers if I'm using the stock results slide or is setting a passing score enough? Looks like the default is scorepoints greaterthan or equal to passpoints. But I'm not quite sure what the difference between scorepercent/points and passpercent/points is.
Attached are the triggers that are in there now, but I'm not quite sure if this is the correct situation.
The .PassPercent and .PassPoints variables store the amount needed to pass the quiz.
The .ScorePercent and .ScorePoints variables store the amount achieved by the user.
Note: Percentage ranges from 0 to 100%. Points are based on how many point you assign to each question. The default is 10 points per question. However, in Form View, you can assign a different point value.
The default triggers on a standard Results slide will show the Failure layer when the user's score is less than (<) what's required to pass. When the score meets or exceeds (≥) the requirement, it will show the Success layer. That will happen based on the passing score you set.
There's lots of info about quizzes and results in the User Guide: https://community.articulate.com/series/articulate-storyline-360
Thanks, Judy! That's all super helpful. So am I correct in my thinking that when using the stock results slide, the passing score is all I need to set to ensure the success/failure layers are appearing at appropriate times? No playing with triggers here unless I want a different result?
Yup. 😁
Man, this community is the best. Thanks again, Judy!
