Forum Discussion
Jeopardy quiz issue (Help)
I downloaded a neat Jeopardy style game template, I used it and tweaked it a bit! However I'm having some serious issues with the result slide.
What is supposed to happen is, the learner needs to get at least 6000 points in order to succeed but no matter what I do when I test it ... it always shows the failure layer even if I hit 6000 or higher.
I been messing with this for hours, can someone help me figure out why this may be the case? I have attached an example and the storyline file! Keep in mind all middle bubbles are the correct answer and the top and bottom bubbles are incorrect)
https://360.articulate.com/review/content/68949c3c-eb2d-494c-a839-61ca0904ff58/review
Someone smarter than me will have to explain why this worked (darned if I know), but here's what I did:
- On 6.2, I went into the Quiz Settings and identified which questions to use (the check mark for scoring viewed slides only was for my Jump shortcut).
- I tired removing 12.2 but for some reason it removed the ResultsPass and ResultsScore variables, so I removed the triggers that adjusted the scores on that results slide. This left only 6.2 as the only results slide using the variables.
You'll see the score change on the main scoreboard screen, and can jump to the results slide when you get over 6000. Saves a lot of clicking.
Thank you so much, this was giving me such a a headache! I love the short cut I'm going to use that next time! I just couldn't figure it out if it was a variable issue or what!
Thank you again!
