I need an object to move on a "curve" path for about 2 minutes. SL appears to have a limit of 59 seconds.
In the attached SL file the red and blue aircraft fly along the "curve" path shown, but adding a second (more direct) path to the blue aircraft does not result in the two paths being followed one after the other as i'd hoped - it just follows the more direct path.
Disregard the box at the top. Go to the timeline and stretch it out as long as you would like. Then stretch the motion path out as long as you would like. Next grab the little square box and stretch it out to the length of the flight.
4 Replies
Not seeing the file.
Disregard the box at the top. Go to the timeline and stretch it out as long as you would like. Then stretch the motion path out as long as you would like. Next grab the little square box and stretch it out to the length of the flight.
Any problems let meknow
Many thanks Eric, that seemed to do the trick. I wondered what the yellow box was for, is there any doc describing what's going on there?
Mike, not sure if you ever figured this out but, the little box can be starched out to sow the movement on the path down.