Forum Discussion
Triggers/Layers Not working correctly
Hello -
I am creating a course where the learner looks for errors in a spreadsheet. When they click on the correct error, they get a congratulations message, and that hotspot is disabled.
Whe...
Like Joe says, this setup will work only if the learner clicks the errors in exactly the same order as the triggers. You can easily observe this by altering the order you use to test it. You should get different results with different sequences. The answer is not to disable the hotspots until afterward, perhaps when the question layer starts.Then you can re-write these triggers to "Show layer XXX if a certain error is the one clicked". I would make all the errors a Button Set, and use Selected state.
