Hi folks, my avatars aren't appearing in slides after initial selection. I'm building out from the slider that Nicole created. I've attached the relevant slides from my module. It appears that my triggers aren't set properly. How should I correct them? Thanks, Paul.
Are you copying/pasting them in? Importing them in? I'd err towards the latter following the steps here. Did you check that you're working locally? Working with files off a network or shared drive is known to cause issues.
You'll also see that in Michael's example he's not using the when element of "when Slider1 Changes" as that trigger is looking for the variable change to occur on that slide. If you've got the slides back in your file and they're still misbehaving can you share that copy here again?
3 Replies
See attached a revised file, with fixed triggers on slide 1.3.
Thanks Michael. That works great. When I embed these slides back into my module, they don't work. The triggers are exactly the same.
Hi Paul,
Are you copying/pasting them in? Importing them in? I'd err towards the latter following the steps here. Did you check that you're working locally? Working with files off a network or shared drive is known to cause issues.
You'll also see that in Michael's example he's not using the when element of "when Slider1 Changes" as that trigger is looking for the variable change to occur on that slide. If you've got the slides back in your file and they're still misbehaving can you share that copy here again?
This discussion is closed. You can start a new discussion or contact Articulate Support.