When I click on the review button from the success layer of an assessment, it goes to the first wrong answer as normal (and shows what the correct answer should have been). From here, when I click on the next button it just works it way through the remaining questions in the assessment, with the 'incorrect bar' showing at the bottom, even although these questions were answered correctly.
Any ideas on how to fix this would be greatly appreciated.
Thanks for reaching out and sharing what you are experiencing with your project during the review.
It sounds like your slide properties are Reset to initial state. I'd recommend adjusting them to Automatically decide and see if it displays as expected.
The slide properties are Reset to initial state but this is required for when the learners fail the assessment. There are two failure layers, one for a score percentage between 50-79 and one for a score percentage of <50. When the score percentage is between 50-79, the learners have to review the content for the questions they got wrong and then retake the assessment. So to make this work each question slide has certain variables within them, so that is why we set them to reset. I will try changing the slide properties and see what happens.
Adding the retry button and review button on the appropriate failure layer should accomplish what you mentioned above.
Let me know what you find. If you decide to have us look at your project file to investigate what's happening, you can share it publicly here or send it to me privately by uploading it here. I'll delete it when I'm done troubleshooting.
3 Replies
Hello Allison,
Thanks for reaching out and sharing what you are experiencing with your project during the review.
It sounds like your slide properties are Reset to initial state. I'd recommend adjusting them to Automatically decide and see if it displays as expected.
This post was removed by the author
Hi Leslie
Thanks for the response and suggestion.
The slide properties are Reset to initial state but this is required for when the learners fail the assessment. There are two failure layers, one for a score percentage between 50-79 and one for a score percentage of <50. When the score percentage is between 50-79, the learners have to review the content for the questions they got wrong and then retake the assessment. So to make this work each question slide has certain variables within them, so that is why we set them to reset. I will try changing the slide properties and see what happens.
Kind regards
Allison
Thanks, Allison.
Adding the retry button and review button on the appropriate failure layer should accomplish what you mentioned above.
Let me know what you find. If you decide to have us look at your project file to investigate what's happening, you can share it publicly here or send it to me privately by uploading it here. I'll delete it when I'm done troubleshooting.