I converted your spinner to a dial control. Now all you have to do is change the timing of each trigger to match your narration. Take a look at the attached project file.
Hi Don, Thanks for responding. Unfortunately I have Storyline 2 and am not able to open the slide. Can you explain how you did this? Is the functionality available in S2? This is so frustrating as it took me all of 5 minutes to do this in PPT. Thanks. Lynn
Thanks for helping me in this thread by re-working my dial.
So, I am trying to simply duplicate this slide as a review, but the dial does not seem to be working. I adjusted the timing to match this new slide from the previous one I used. Could you take a look and let me know why the dial is not ticking down?
It looks like you have the variable "Group11" set for the slider, but the triggers are referencing the variable "Group1". If you switch the dial setting to "Group1", or the triggers to "Group11" you should see the dial move.
8 Replies
I converted your spinner to a dial control. Now all you have to do is change the timing of each trigger to match your narration. Take a look at the attached project file.
Michael,
Thank you very much. That was brilliant.
You're welcome. I hope that works well for you.
Hi Don, Thanks for responding. Unfortunately I have Storyline 2 and am not able to open the slide. Can you explain how you did this? Is the functionality available in S2? This is so frustrating as it took me all of 5 minutes to do this in PPT. Thanks. Lynn
Lynn, I replied to you in the other thread here https://community.articulate.com/discussions/articulate-storyline/rotate-clock-hand#reply-440381
Hey Michael,
Thanks for helping me in this thread by re-working my dial.
So, I am trying to simply duplicate this slide as a review, but the dial does not seem to be working. I adjusted the timing to match this new slide from the previous one I used. Could you take a look and let me know why the dial is not ticking down?
Thanks,
Don
Hi Don,
It looks like you have the variable "Group11" set for the slider, but the triggers are referencing the variable "Group1". If you switch the dial setting to "Group1", or the triggers to "Group11" you should see the dial move.
I hope this helps!
Mike
Hello Mike,
That worked out perfectly. Thanks for the catch. I am just learning about variables.
This discussion is closed. You can start a new discussion or contact Articulate Support.