I have two similar problems. I have button1, by clicking on this button? the layer1 which must be opened, and again when you click on button1, layer1 must close. And so on, clicked -> opened again clicked ->shut.
How to do it?
How to change the state of the button when clicked multiple times?I clicked once the state has changed from 1 to 2, clicked once again the state has changed from 2 to 1.
Hi, Alexandr -- Thanks for your question! If you are looking for design ideas, you may want to share your file here so that others are able to take a look and make suggestions. Please use the ADD ATTACHMENT button in the bottom left corner of the reply box in the thread, and you can browse for the file from there. Please also note that if you reply via email, your attachment will not appear here in the thread.
Thanks so much for your suggestion and the file you shared, Walt! Please let us know if that is what you had in mind, Alexandr, or if you still need further assistance.
5 Replies
Hi, Alexandr -- Thanks for your question! If you are looking for design ideas, you may want to share your file here so that others are able to take a look and make suggestions. Please use the ADD ATTACHMENT button in the bottom left corner of the reply box in the thread, and you can browse for the file from there. Please also note that if you reply via email, your attachment will not appear here in the thread.
You are also welcome to post over in the Building Better Courses forum, as well. :)
Show/Hide layer
The attached file only works if there is nothing on the layer that covers the button on the base. If something is covering it, you cannot click on it.
I put a rectangle on the layer, but since it has no fill, it does not cover the button.
Slide 2 shows a much easier method, but I think both methods look the same to the user.
Change button state
Slide 1 button changes state when clicked.
Thanks so much for your suggestion and the file you shared, Walt! Please let us know if that is what you had in mind, Alexandr, or if you still need further assistance.
Hello, thanx for good solution. It's work. Before you solution i use another method whith two buttons
Thanks so much for the update and for sharing your file, Alexandr!
This discussion is closed. You can start a new discussion or contact Articulate Support.