Just about to start a new project and trying to get ahead of the workload...
what were going to be trying to do is put up a slide. it has valves, probably about eight or so, I was wondering if its possible to set up a way to where they have to click on the right 4/8 or 6/8 for it to bring a right or wrong slide up.
Welcome to the community. You should be able to set something like this up using the Quiz slide "freeform pick many". You can insert whatever images you need, and then under form view, you set up which ones are select-able, and which ones are correct. There will be a default "correct" and "incorrect" layer that appear once submitted, but you could remove these, or customize them, and have your own right/wrong layers to appear.
3 Replies
Hello Ryan!
Welcome to the community. You should be able to set something like this up using the Quiz slide "freeform pick many". You can insert whatever images you need, and then under form view, you set up which ones are select-able, and which ones are correct. There will be a default "correct" and "incorrect" layer that appear once submitted, but you could remove these, or customize them, and have your own right/wrong layers to appear.
thanks a ton, I assumed there was an article I was missing somewhere
No problem, good luck with your project!
This discussion is closed. You can start a new discussion or contact Articulate Support.