Hi there. I'm at a loss currently with a slide that I've created in a program that is set to launch in a few weeks. Looking to see if anyone has any suggestions or insight on WHY my 'Scone' state is doubling up .... I can't for the life of me figure it out and am hopeful someone on here can assist .... TIA!
The only thing that jumps out at me is that there is an unassigned trigger that is only visible when I put scone's states into edit mode. That trigger, while pointing to an unassigned object, sets a state of "normal" in addition to the actual state on the object.
Great eye, Matt. And thanks for taking a peek. I feel like this is one of those situations where I should just start fresh. Thanks again for your insight!
2 Replies
The only thing that jumps out at me is that there is an unassigned trigger that is only visible when I put scone's states into edit mode. That trigger, while pointing to an unassigned object, sets a state of "normal" in addition to the actual state on the object.
Oddly, I can't seem to edit those triggers.
Great eye, Matt. And thanks for taking a peek. I feel like this is one of those situations where I should just start fresh. Thanks again for your insight!
This discussion is closed. You can start a new discussion or contact Articulate Support.