Slide doenst advances automatically when revising Jun 29, 2012 By Ana Victória Hello, I have a slide that advances automatically when timeline ends. It works fine the first time. When I review that slide it doesn't advances!!
Bruce Graham Hero almost 12 years ago06/29/12 at 4:15 am (UTC) Hi Ana, When you say "Review", do you mean "View it again". So...you look at that slide (after publishing), you go to the next slide, then you go back to the original again, and it does not go on automatically? Bruce
Ana Victória Author almost 12 years ago06/29/12 at 4:31 am (UTC) Yes Bruce, exactly. That slide is an introduction to a video and is supposed to advance automatically. I set the trigger to "go to next slide when timeline ends" and when revisiting "reset to initial state". Is it correct? Ana
Nancy Woinoski Hero almost 12 years ago06/29/12 at 5:23 am (UTC) Instead of using a trigger to advance when timeline ends, try setting the "Slide advances" property to Automatically. Then if you have the revisting set to "reset to initial state, you should get the results you want.
Ana Victória Author almost 12 years ago06/29/12 at 5:43 am (UTC) hum... I already have that. I posted a print for you to see my settings... I thing that trigger shows up when you sett the slide advances automatically, right? What am I doing wrong? Ana
Nancy Woinoski Hero almost 12 years ago06/29/12 at 5:50 am (UTC) that looks to be the correct setup - any chance you can post the story file?
Ana Victória Author almost 12 years ago06/29/12 at 6:15 am (UTC) Yes I can make a short version. How to post it? Attach it here?
Nancy Woinoski Hero almost 12 years ago06/29/12 at 6:27 am (UTC) You should be able to upload the story file here. Just click the paperclip icon.
7 Replies
Hi Ana,
When you say "Review", do you mean "View it again".
So...you look at that slide (after publishing), you go to the next slide, then you go back to the original again, and it does not go on automatically?
Bruce
Yes Bruce, exactly.
That slide is an introduction to a video and is supposed to advance automatically.
I set the trigger to "go to next slide when timeline ends" and when revisiting "reset to initial state". Is it correct?
Ana
Instead of using a trigger to advance when timeline ends, try setting the "Slide advances" property to Automatically.
Then if you have the revisting set to "reset to initial state, you should get the results you want.
hum... I already have that.
I posted a print for you to see my settings... I thing that trigger shows up when you sett the slide advances automatically, right?
What am I doing wrong?
Ana
that looks to be the correct setup - any chance you can post the story file?
Yes I can make a short version. How to post it? Attach it here?
You should be able to upload the story file here. Just click the paperclip icon.
This discussion is closed. You can start a new discussion or contact Articulate Support.