slider and video
Jun 12, 2015
By
Peter Vajda
I'd like to use a slider with 10 stops to show a video. With the video beginning at stop 1, the stop 2, stop 3, etc., stopping every 3 seconds.
I'm attaching the file and I cannot get it to stop and start at the times I want.
Also, in the triggers window, why can't I move the slider trigger, the lowest one, up a notch? I though they played in order as as they appear now, thy are not in the order I want things to happen.
Thank you.
Peter
11 Replies
Hi Peter
the video option was set to start automatically so I changed it to be 'from trigger'. I then adjusted the first two triggers of the slider so it starts when slider moves to 1 and pauses when slider moves to 2 - maybe you can play around with these settings and see if it works for you.
HI Wendy,
So, I'm keeping the video with it's original "pause" at start of timeline. I don't want it to start until after I've moved the trigger so I set the slider to move upon release. Now, I move the slider to its first "step" (is step the right term?; there are ten "steps") and then the video starts
See the triggers on the attached.
BTW, how did you get to place a screen grab in this note and I can't?
Then I want the video to pause when it reaches cue #1 on the timeline; it does not.
What trigger(s) do I use so pause the video at the 2nd "step" instead of the 2nd cue? Can I do that?
Can I stop the video and then play it at the same cue and at the same step?
Thanks for taking the time.
Peter
Not sure I completely understand.
If you want to set a trigger to pause a video at a cue point then set a trigger to pause media when timeline reaches that cue point. If you want to use a slider to jump to specific points in a video then that is not possible.
You may be able to achieve similar by using the payer controls and set increments along the scrubber but you would not be able to pause the video
Thanks Phil for taking the time.
First, I'm new to this so I have no idea what this means. "You may be able to achieve similar by using the payer controls and set increments along the scrubber but you would not be able to pause the video"
As for, "If you want to set a trigger to pause a video at a cue point then set a trigger to pause media when timeline reaches that cue point."
I used that trigger (see the attaced word.doc); It does not pause/stop.
If you want to use a slider to jump to specific points in a video then that is not possible."
That's OK, this not what I wish to do.
Thanks aghain.
Peter
sorry I meant video controls this can be added under show video controls.
If the video is not playing automatically when the slide starts this is probably why the cue point triggers do not work.
Thanks Phil.
"If the video is not playing automatically when the slide starts this is probably why the cue point triggers do not work."...and so? Any suggestion?
Peter
You could set the video to start automatically or set a trigger to show a layer when your media starts which has the cue points set up to pause the media.
Or duplicate the base layer (this way you don't need to set up the cue points again) with your video on and just have an image of the video on the base layer with a play button which actually shows the layer (on the layer the video would be set to play automatically.
Thanks, Phil. I give these a shot.
Peter
Glad to see that you are still getting the assistance that you need here Peter.
Thanks Leslie. What to do about posts that go unnoticed? Can/should I re-post?
If it was over the weekend, I would give us a chance to catch up. I'm not sure what post you are referring to though.
This discussion is closed. You can start a new discussion or contact Articulate Support.