I am new to Storyline 360 and am very much a beginner. I had developed two slides and had triggers established to not advance until the slide until all layers were visited. Everything was working perfectly, until it wasn't. The triggers are no longer working. Can anyone take a look and offer some insight?
Sure - so based on your current build, you are forcing the order in which the tabs can be selected. The main challenge is that you have all of the tabs repeated on each layer - clever design, but can complicate the process.
The easiest solution in your current design would be to add a condition to your next button that says "if the state of Tab 04 = visited" The tricky part is making sure you choose the "Tab 04" option that lives on Layer 3, since there are 5 different objects named "Tab 04"
5 Replies
Hello Kim,
It looks like you removed some of the functions from the trigger. Your next buttons are currently unassigned.
Yes, sorry, Ron. It looks like not all slides copied from the scene.
Hope this helps. I'd rather not post the full scene.
Sure - so based on your current build, you are forcing the order in which the tabs can be selected. The main challenge is that you have all of the tabs repeated on each layer - clever design, but can complicate the process.
The easiest solution in your current design would be to add a condition to your next button that says "if the state of Tab 04 = visited" The tricky part is making sure you choose the "Tab 04" option that lives on Layer 3, since there are 5 different objects named "Tab 04"
See below - I hope this helps
Thank you so much. This explanations was very helpful!