Forum Discussion
Trigger Jumps to Wrong Cue
Any fix for this yet? I have a cue point 1 set at 5 seconds. At that point a button appears and I have a trigger set to pause timeline at the cuepoint 1. This works. However, The button is triggered to jump to either a cuepoint 2 or time of 32 seconds on the timeline.
When testing, the timeline (video) does pause, but when I click the button it just continues from where it paused, it does not jump to the 32 second mark.
It seems that the cuepoint and timeline triggers get confused when the Seek bar for the slide is turned off and the video controls for the video in the slide are turned on, there is no correlation.
Using cue points and jumping to timeline times wont work at all.
Is there a way to control the Video timeline and not the Slide timeline with triggers jumps?
This is important for being an accessible interactive video slide. The video timeline and the Slide timeline are working independent so if the video is paused then the timeline could still be running. I tried setting the trigger to pause the video and also pause the timeline, but then again the timeline starts but the video stays paused... confusing
Is this the same bug?