I set up my course to branch halfway through. I set up a menu slide and put hyperlinks on the "buttons" to take learners to specific slides. At the end of each group of slides, I selected "slide 10" to return the learner back to the "menu" slide. Instead, Presenter is taking the learner back to my Course Objectives slide (slide 1).
I do NOT have the navigation set to restricted. In fact, I have it set to Free. I've attached a screenshot of my slide properties in case the problem is obvious.
I see that you have slides 14, 15 and 19 branching to slide 10. Are all of these slides taking you to slide 1?
I did notice that slide 15 and slide 11 are jumping to 10, but with the previous button. That makes sense for slide 11, but not sure if that was intended for 15.
Also, I noticed that slide 10 is locked. Is that intentional, as well?
If you'd like, you're welcome to attach a Presenter Package here. I'd be happy to take a closer look and see what's happening.
1 Reply
Hi there Cheryl,
I see that you have slides 14, 15 and 19 branching to slide 10. Are all of these slides taking you to slide 1?
I did notice that slide 15 and slide 11 are jumping to 10, but with the previous button. That makes sense for slide 11, but not sure if that was intended for 15.
Also, I noticed that slide 10 is locked. Is that intentional, as well?
If you'd like, you're welcome to attach a Presenter Package here. I'd be happy to take a closer look and see what's happening.
Thanks!
This discussion is closed. You can start a new discussion or contact Articulate Support.