Get error message when attempting to publish

Apr 02, 2017

When I attempt to publish my Power Point file using Presenter 13, I receive an error message, saying that something went wrong and asks me to send it for an error report.  I've attached the error message and the file.  Can someone help me determine what is wrong? I'd hate to have to recreate the whole thing piece by piece to figure it out.  I'm on a deadline...error message

1 Reply
Leslie McKerchie

Hello Cappie - Thanks for sharing your file and allowing us to take a look. I experienced the same issue you are describing here. The course also fails upon preview. 

I started previewing 3 slides at a time, and I know that Slide 13 is a culprit. I did not go any further than that (so it could be the only culprit).

I would advise re-building this slide and proceeding from there.

This discussion is closed. You can start a new discussion or contact Articulate Support.