Problem with after publishing presentation for LMS

Jun 28, 2011

prashanth udupa
By prashanth udupa

Hello There..

I've problem with publishing presentation for LMS. Listed below:

1. If i give wipe animation for the text, after publishing some of the last letters in the text not visible.

2. In some cases symply it takes some gap in between the word which is not in the PPT.

3. In some case image border will not be visible even it is there in PPT.

Thanks in advance for reply...

5 Replies
Brian Batt
almost 13 years ago06/29/11 at 9:28 am (UTC)

Hi Prashanth & welcome to Heroes,

If you add a Wipe animation to a presentation you may find that the animation does not complete. Please review this article which outlines suggestions to resolve this issue: 

http://www.articulate.com/support/presenter09/kb/?p=442

In regards to your second issue, can you post a screenshot of the issue with the gap?

In regards to your third issue, would you mind submitting a support case so that we can take a closer look at the issue?

http://www.articulate.com/support/contact/

prashanth udupa
almost 13 years ago07/04/11 at 5:00 am (UTC)

Hello Sir,
 
 
Thank you for the 1st point solution.
 
For the second one I've attached image here with arrow mark. We need to publish it several time to eradicate this space. This gap may come any part of the paragraph.
 
For third one we will setup meeting.
 
Thank you for your kind co-operation. 
 
Prashanth

Brian Batt
almost 13 years ago07/06/11 at 9:53 am (UTC)

In addition to Gerry's reply, you may need to check to see if you copied and pasted the text from another program like Microsoft Word.  If you did, copy and paste the text into Notepad.  This will remove the extra formatting creating by Microsoft Word.  Then, copy and paste the text from Notepad back into PowerPoint.  I've seen that workaround resolve several similar issues.

This discussion is closed. You can start a new discussion or contact Articulate Support.