Object Layers for Drag and Drop

Aug 28, 2014

Hello!

I was trying to do a sort of simulation with a card reader, and I have it set up to appear as if the card is swiping into the card reader. But when I preview, it puts the card on the top layer, and doesn't look how I want it. Below are som screenshots so you know what I am talking about.

(As you can see in the below image, the card fits into the card reader like it would in real life. **Note, that is not the starting position of the card, but only in this spot for demonstration. The card starts above the card reader.)

But when I go into preview mode, it acts like the layers no longer matter.

Any advice or fix to this? If there is another way of achieving what I am wanting to do, I am open to suggestions!

2 Replies

This discussion is closed. You can start a new discussion or contact Articulate Support.