In order for the reload control to work, the slide must be configured to reset to initial state.
I see others around me forgetting this as well, therefore, I do think there was a change, but personally, I have alsways done this setting, so cannot tell you from my experience.
As stated, I have to show others around me to make this change (since update 5) where I did not have to in the past.
I don't see anything within our release notes that we modified the behavior, and you can see the description here of how the rewind button is designed to work so you could use "reset to initial state" or "automatically decide."
Thank you very much, yes it works but only if I insert an invisible button that changes state to move forward, not work. In that case I have to use variables. Thanks
I'm not sure how you're setting up this invisible button, but if you're still experiencing some difficulty, would you like to share your Storyline file here with us to take a look at?
4 Replies
Hi Pizarro:
In order for the reload control to work, the slide must be configured to reset to initial state.
I see others around me forgetting this as well, therefore, I do think there was a change, but personally, I have alsways done this setting, so cannot tell you from my experience.
As stated, I have to show others around me to make this change (since update 5) where I did not have to in the past.
Best Regards,
Dennis Hall
Hi Pizarro and welcome to Heroes!
I don't see anything within our release notes that we modified the behavior, and you can see the description here of how the rewind button is designed to work so you could use "reset to initial state" or "automatically decide."
Thank you very much, yes it works but only if I insert an invisible button that changes state to move forward, not work. In that case I have to use variables. Thanks
Sorry for my English
Hi Pizarro,
I'm not sure how you're setting up this invisible button, but if you're still experiencing some difficulty, would you like to share your Storyline file here with us to take a look at?
This discussion is closed. You can start a new discussion or contact Articulate Support.