I am at the end of producing my first course. Some of the slides will not replay / refresh from the seeker bar. It seems to be on the slides where I have used markers, although on one slide there is no marker and it still wont refresh / replay.
I just can't figure it out. Any ideas gratefully received so I can fix.
Under the slide properties for the slides that don't replay (the gear icon in your slide layers) check the property setting for When revisiting:. For the replay button to function properly, it needs to be set to Reset to initial state. The same goes for layers that you have the seekbar active.
If it's not set to Reset to Initial, and if the auto detect thinks you might want to keep things as they are when returning, the slide will always resume where you left off. Even using the replay button, which will always be the current place on the timeline.
3 Replies
Hi Ruth,
Under the slide properties for the slides that don't replay (the gear icon in your slide layers) check the property setting for When revisiting:. For the replay button to function properly, it needs to be set to Reset to initial state. The same goes for layers that you have the seekbar active.
If it's not set to Reset to Initial, and if the auto detect thinks you might want to keep things as they are when returning, the slide will always resume where you left off. Even using the replay button, which will always be the current place on the timeline.
Hi Ruth,
Please Check the settings mentioned in the below Picture(Right click in the slide area and select "Properties" to go into these settings)
If You Select "Return to Initial state" ,"Replay" would work
If you Select "Resume saved state" Replay would not work
If you select "Automatically decide" Sometimes replay would work and sometimes it would not work depending upon the triggers you have used
Hope this works
Thank you both so much you have saved me an inordinate amount of time! Ruth
This discussion is closed. You can start a new discussion or contact Articulate Support.