I have a large S360 course where I want the automatic slide numbers to appear in (roughly) the same order the slides will be presented. When I finish adding all of the slides to a scene, I can renumber them by dragging them to the slide I want them to be numbered after in Story view. This works great. However...
When I do that, the "When the user clicks Next jump to slide..." trigger automatically resets to "next slide," even though I have already defined the target slide by name. This becomes problematic when there is branching within the scene or when I want to be completely sure the correct next slide is defined. Basically, I have to go into every slide and re-define the target slide.
Any workarounds on this, or should I submit a change request?
To my knowledge, that has never happened before. I have always used "Jump to specific slide name" to protect my slide order from changing when the slides are renumbered by dragging.
Have you recently installed a new update? This should definitely reported.
We can definitely help! I'd like my team to take a look at your project to report this behavior. You can connect with our Support Engineers by submitting a support case.
4 Replies
To my knowledge, that has never happened before. I have always used "Jump to specific slide name" to protect my slide order from changing when the slides are renumbered by dragging.
Have you recently installed a new update? This should definitely reported.
Hi Janet!
We can definitely help! I'd like my team to take a look at your project to report this behavior. You can connect with our Support Engineers by submitting a support case.
Thanks, Lauren. Support ticket sent!
Thanks, Janet. I can see that Johnrey is taking a look.