I am not sure if there is a solution to it but I wanted to bring this to the attention of the SL staff for further fixes. I am working in SL 360 and never experienced this issues in SL 2 or 1. Quite often, after adjusting some elements on the slides, branching breaks down and I have to rebranch the slides again. Would appreciate advice if there is any.
If the triggers branch to "next slide" instead of a named slide, I find that even the smallest twitch while selecting the slide from slide view can rearrange the slide order.
Thank you both! As I was rearranging them I noticed that some of them were leading to the Next slide, as Walt mentions. Will take Walt's advice to always branch to a specific slide instead of the next one. Thanks again!
3 Replies
What do you mean by rebranch?
The flow of the slides will be based on the triggers from one slide to the next. Are you saying the triggers are disappearing?
If the triggers branch to "next slide" instead of a named slide, I find that even the smallest twitch while selecting the slide from slide view can rearrange the slide order.
Thank you both! As I was rearranging them I noticed that some of them were leading to the Next slide, as Walt mentions. Will take Walt's advice to always branch to a specific slide instead of the next one. Thanks again!
This discussion is closed. You can start a new discussion or contact Articulate Support.