I've set a trigger to "Restart Course" on the "Start Over?" button contained within the "visits successfully completed" layer. And, I've set the slide properties to initial state. However the course does not appear to restart properly.
I've also tried setting a trigger to jump to time zero, as a workaround, but I get the same behavior (pin icons not appearing upon restart.) This is very likely pilot error. 🤷♂️ I appreciate any insights.
If you're trying to reset the positions of the objects in your slide, you can try using this trigger instead of the 'Restart Course' trigger:
What this does is essentially reload your slide. And since you have the revisit behavior set to 'Reset to initial state', all of the objects will be in their initial positions when the slide loads. I've attached a revised version of your copy file so you can test out the trigger above.
2 Replies
Hello!
If you're trying to reset the positions of the objects in your slide, you can try using this trigger instead of the 'Restart Course' trigger:
What this does is essentially reload your slide. And since you have the revisit behavior set to 'Reset to initial state', all of the objects will be in their initial positions when the slide loads. I've attached a revised version of your copy file so you can test out the trigger above.
That works. Thank you!