I have a quiz using free form "Pick One", with a few choices. Right now I select on a choice it will change to a "Select" state, but when I click on another the previous one still remain in "Select" state.
What I want to achieve is, when I make another selection the previous choice should revert back to "Normal" state. Is it possible with this type of Question?
Thanks Parichaya, that was what I original have in mind too. But it just took a bit of time to customize it that way, if I have several questions. I was hoping that there are other ways to tackle this. Let's see, if not then I will have to go down this path.
5 Replies
Hi Virak,
Just applied some triggers and I think so I got what you wanted.
Check out the story file attached. You can get to know about the triggers that I used.
May be this would be helpful.
Best Regards,
Parichaya
Thanks Parichaya, that was what I original have in mind too. But it just took a bit of time to customize it that way, if I have several questions. I was hoping that there are other ways to tackle this. Let's see, if not then I will have to go down this path.
Thank you!
Virak
Yeah I know lot of triggers...... but it would be better if you find out other ways if you have a huge bunch of questions.
Incase, if you find something else please do share.
Thanks & Regards,
Parichaya
Ok, I found the easiest way. Make them as "Button Set"
This is easier than using the trigger. :D
Virak
Yes, button sets is the way to go in this case. See here for some info on buttton sets.
This discussion is closed. You can start a new discussion or contact Articulate Support.