Ran into a strange problem with triggers
Nov 26, 2019
I have a slide with two buttons on it. One path sends the learner to an alternate set of slides and the other continues in a different direction. I cannot change the buttons to trigger the direction I want each to go.
When I add a trigger to button 1 - the same trigger goes on the alternative button 2 path. I have no idea how to stop this from happening as I have never run into this problem before. It doesn't matter how many times I change each - I change one and the other ends up with the exact same trigger - I am ready to pull my hair out! What am I missing?
Nancy
1 Reply
Hi Nancy,
can you send us your slides (or a dummy with the same behavior) to have a look into this? Normally this shouldn´t happen. :) Did you group your buttons by any chance? Because this could cause the problem too.
Regards
Susi
This discussion is closed. You can start a new discussion or contact Articulate Support.