I have created a "try" simulation and wanted to add a layer showing the full instructions for the simulation. When I open the instruction layer, everything works correctly, but when I click the slide layer close button, I get the Try Again layer instead of just taking me back to the base layer, can this be fixed? I attached a few slides as an example.
I had a quick play around with your file. On the instruction layer change the properties so that the user is prevented from clicking on the base layer (see below).
It seems that clicking the 'X' to close the instruction layer was triggering the slide trigger on the base layer to show the incorrect layer if clicked outside of hotpsot...
3 Replies
Hi Stephanie,
I had a quick play around with your file. On the instruction layer change the properties so that the user is prevented from clicking on the base layer (see below).
It seems that clicking the 'X' to close the instruction layer was triggering the slide trigger on the base layer to show the incorrect layer if clicked outside of hotpsot...
Seemed to do the trick when I played with it :)
Hi Shaun,
Ahhhhh!!!! Thank you so much! It hadn't even occurred to me to look at the slide layer properties. You're a life saver :)
No problem. Glad it sorted the issue!
This discussion is closed. You can start a new discussion or contact Articulate Support.