STL-1 conversion to STL-2: Screen Recording Alignment Problem

Feb 08, 2016

I converted a course to STL-2. and it includes lots of screen recordings.

After to converting to STL2 I changed the story size to a larger display.

All the step-by-step screen recordings are now left-justified and I can not center them on the slide.

How can I change the screen recordings on the slide to be centered. I do not want to re-records all the screen recordings!

Attached is a screen-shot of the offset that I am trying to center.

3 Replies

Ashley Terwilliger-Pollard
Staff

8 years ago02/08/16 at 8:43 pm (UTC)

Hi Ray,

What did you choose in terms of how the story size should behave when changing it from what you previously used as detailed here?

8 years ago02/08/16 at 8:58 pm (UTC)

Thanks for the quick reply!!

I set everything as required as outlined in the instructions. All the
prepared slides are correctly center-middle as expected but none of the
screen-recordings slides (view mode) are center-middle.

Thanks,
Ray

Ashley Terwilliger-Pollard
Staff

8 years ago02/08/16 at 9:16 pm (UTC)

Hi Ray,

I suspect it's based on the screen recordings being inserted as a part of the background and therefore not changing their position on the slides. Have you tried inserting the screen recording slides again and see if that gives it a reset?

STL-1 conversion to STL-2: Screen Recording Alignment Problem

3 Replies

This discussion is closed. You can start a new discussion or contact Articulate Support.