I would like to know what trigger I need to use after a video plays in my lesson. Right now, the user closes the video with the X on the video screen and it goes back to the slide that started the video instead of the next slide. I have made a trigger that say to go to the correct slide when media finishes but then the screen where the video was still shows. Does the user have to stil click the x to get rid of that screen? and if they do in mine it goes to the slide that introduces the video?
The video is part of a course so the course runs, the viewer clicks the screen to view the embedded video (lets say slide 6), the video runs and when the video finishes, the user clicks the x to escape from the video and I would like the user to now be on slide 7.
6 Replies
When media completes should do that are you only previewing a single slide?
The video is part of a course so the course runs, the viewer clicks the screen to view the embedded video (lets say slide 6), the video runs and when the video finishes, the user clicks the x to escape from the video and I would like the user to now be on slide 7.
Hi Susan! Could you share your .story file so that we can see how you have this set up?
Sounds like you are using a lightbox that creates a little red X in the top right of the pop-up window.
Is this correct?
LOL, I just noticed this was from 4 years ago.
Never too late to pop in to assist, right Kyle? Not sure you are going to get a response though :)
This discussion is closed. You can start a new discussion or contact Articulate Support.