I created a pie chart and wanted to use a dial to show each layer. Would I be able to change the dial steps to stop at each section since they are not all equal? see attached.
You could change the end value of the dial properties to larger number, like 360, and then have the layer trigger be "Show layer X when dial turns If Dial is between 1 and 40. It might take a while to create the interaction.
I would suggest instead of a dial use either "Show layer when shape (a section of the pie chart) is clicked" or "Show layer when shape (a section of the pie chart) is hovered over.
1 Reply
You could change the end value of the dial properties to larger number, like 360, and then have the layer trigger be "Show layer X when dial turns If Dial is between 1 and 40. It might take a while to create the interaction.
I would suggest instead of a dial use either "Show layer when shape (a section of the pie chart) is clicked" or "Show layer when shape (a section of the pie chart) is hovered over.
This discussion is closed. You can start a new discussion or contact Articulate Support.