The user may choose to take the standard or accessible assessment. I have set up a question bank for each path. However, I need one results page for publishing. I can get the results page to call the variable for one of the assessments. What I need is for the results page to recognize which question bank/results variable was accessed. Then report that result. It will only recognize one. It does not seem to allow for an either/or.
This is for 508 compliance. It's a must. Randomizing is also a must.
I found my answer in a forum post from four-five years ago.
I created a results page for each question bank.
The Question Bank results pages show the % score but not the Success/Fail layers. The user clicks next to continue.
I created a Final results page.
The Final results page uses the same text as the Question Bank results pages (both of them had the same introductory text). But, the % score is replaced by the Success/Fail layers. The layers are triggered by an OR condition in the special conditions section of the trigger.
1 Reply
I found my answer in a forum post from four-five years ago.
I created a results page for each question bank.
The Question Bank results pages show the % score but not the Success/Fail layers. The user clicks next to continue.
I created a Final results page.
The Final results page uses the same text as the Question Bank results pages (both of them had the same introductory text). But, the % score is replaced by the Success/Fail layers. The layers are triggered by an OR condition in the special conditions section of the trigger.
This discussion is closed. You can start a new discussion or contact Articulate Support.